Alcatel-Lucent 6850-48 参考指南

Source Learning Commands

page 17-22

OmniSwitch CLI Reference Guide

Displays Source Learning MAC Address Table information for the specified VPLS Service Access Point 
(SAP) binding.

show mac-address-table vpls service-id sap {sap-id | linkagg sap-id} mac-address

An existing VPLS ID number.

The access slot and port number or link aggregate ID (0–31) and encap-
sulation value for an existing SAP (e.g., 1/10:0, 1/12:all, 20:150, 10:all).

A 48-bit MAC address (aa:bb:cc:dd:ee:ff). Valid addresses are any non-
broadcast, non-multicast MAC, and non-IEEE reserved addresses.

N/A

OmniSwitch 9000E 

• The specified VPLS ID and SAP ID must already exist in the VPLS configuration for the switch. See 

the “VPLS Commands” chapter in this guide for information about how to configure a VPLS and SAP.

• A SAP ID is comprised of an access (customer-facing) port or link aggregate and an encapsulation 

value that is used to identify the type of customer traffic to map to the associated service. 

-> show mac-address-table vpls 1002 sap linkagg 16:1006

Legend: Mac Address: * = address not valid

Domain Vlan/SrvcId    Mac Address      Type  Protocol Operation Interface

-----+-----------+-----------------+--------+-------+---------+------------

VPLS    1002        00:01:db:07:03:02   learned   ---     servicing  sap:0/16:1006        

Total number of Valid MAC addresses above = 1

The domain to which the MAC address belongs: VLAN or VPLS.

The VPLS ID number associated with the MAC address.

MAC address that is currently learned or statically assigned.

MAC address management status: learned or permanent. 

Protocol type for the MAC address entry. Note that if the hardware 
source learning mode is active for the port, this field is blank.