Alcatel-Lucent 6850-48 参考指南

Learned Port Security Commands

OmniSwitch CLI Reference Guide

page 18-17

Releases a port that was shut down due to a Learned Port Security (LPS) violation. The specified port 
resumes normal operation without having to manually reset the port and/or the entire module.

port-security slot/port release

The slot number for the module and the physical port number on that 
module (e.g., 3/1 specifies port 1 on slot 3). Use a hyphen to specify a 
range of ports on the same module (e.g. 3/1-16).

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• This command restores the port to the same operational state it was in before the shutdown. This 

includes the activation of any existing LPS configuration for the port.

• Note that when this command is used, all MAC addresses known to the specified port are flushed from 

the switch MAC address table.

-> port-security 2/14 release

-> port-security 4/10-15 release

Release 6.1; command was introduced.

Enables or disables Learned Port Security (LPS) on the switch port(s).

Configures a single authorized source MAC address for a port that 
belongs to a specified VLAN.

Configures a list of authorized MAC addresses by defining a range of 
addresses allowed on the port.

Configures the amount of time in minutes to allow source learning on all 
LPS ports. Also, enables or disables the conversion of dynamic MAC 
addresses to static MAC addresses on LPS ports.

Specifies the maximum number of source MAC addresses that an LPS 
port(s) is allowed to learn.