Alcatel-Lucent 6850-48 参考指南
Ethernet Port Commands
page 19-34
OmniSwitch CLI Reference Guide
September 2009
interfaces transceiver ddm
Configures the DDM administrative status or trap capability.
interfaces transceiver ddm [trap] {enable | disable}
Syntax Definitions
trap
Indicates the enable / disable parameter applies to the traps
functionality.
functionality.
enable
Enables DDM functionality or traps warning/alarm threshold violations.
disable
Disables DDM functionality or traps warning/alarm threshold viola-
tions.
tions.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• DDM capability will vary based on the transceiver manufacturer.
• DDM status must be enabled in order to enable traps; traps are enabled separately.
• Information will be read sequentially from a different SFP at the predefined Polling intervals listed in
the defaults table above. The number of SFPs in the switch will determine how often each SFP is
polled.
polled.
Examples
-> interfaces transceiver ddm enable
-> interfaces transceiver ddm trap enable
-> interfaces transceiver ddm trap disable
-> interfaces transceiver ddm disable
Release History
Release 6.4.2; command was introduced.
parameter
default
ddm
disable
trap
disable
Polling period (not configra-
ble)
ble)
OS6850/9000 - 60 Seconds
OS6400/6855 - 1 second
OS6400/6855 - 1 second