Alcatel-Lucent 6850-48 参考指南
Ethernet Port Commands
OmniSwitch CLI Reference Guide
September 2009
page 19-59
show interfaces capability
Displays default auto negotiation, speed, duplex, flow, and cross-over settings for a single port, a range of
ports, or all ports on a Network Interface (NI) module.
ports, or all ports on a Network Interface (NI) module.
show interfaces [slot[/port[-port2]]] capability
Syntax Definitions
slot
Slot number you want to display.
port
Port number of the interface you want to display.
port2
Last port number in a range of ports you want to display.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• The show interfaces capability command displays defaults settings in two rows of data for each port.
The first row of data, identified by the label CAP, displays the valid user-defined configuration
settings available for the port. The second row, identified by the label DEF, displays the default
settings for the port.
settings available for the port. The second row, identified by the label DEF, displays the default
settings for the port.
• On a combo port configured as either forced fiber or preferred fiber, the status and configuration of the
SFP fiber ports and not the copper RJ-45 10/100/1000 ports will be displayed. See the
• On a combo port configured as either forced copper or preferred copper the status and configuration of
the copper RJ-45 10/100/1000 ports and not the SFP fiber port will be displayed. See the
Examples
-> show interfaces 5/1 capability
Slot/Port AutoNeg Flow Crossover Speed Duplex
-----------+---------+--------+-----------+----------+----------
5/1 CAP EN/DIS EN/DIS MDI/X/Auto 10/100/1G Full/Half
5/1 DEF EN EN Auto Auto Auto
output definitions
Slot
The slot number.
Port
The port number