Alcatel-Lucent 6850-48 参考指南

VLAN Stacking Commands

page 23-22

OmniSwitch CLI Reference Guide

Configures the status of source learning on a VLAN Stacking VLAN (SVLAN) used for tunneling 
customer traffic or on an SVLAN that the IP Multicast VLAN (IPMV) application uses to 
distribute multicast network traffic. 

ethernet-service {svlan | ipmvlan} svid1[-svid2] source-learning {enable| disable}

Specifies an SVLAN for tunneling customer traffic.

Specifies an SVLAN used by IP Multicast VLAN to distribute 
multicast traffic.

The VLAN ID number identifying the SVLAN (2–4094).

The last VLAN ID number in a range of SVLANs that you want to 
configure (e.g. 10-12 specifies SVLANs 10, 11, and 12).

Enables source MAC address learning.

Disables source MAC address learning.

OmniSwitch 6400, 6855-U24X, 9000E

• By default, source MAC address learning is enabled on all the SVLANs.

• Disabling source learning on an SVLAN clears all the dynamically learned MAC addresses associated 

with the VLAN from the MAC address table. 

• Static MAC addresses associated with an SVLAN are not cleared when source learning is disabled for 

the SVLAN.

• Configuring the source learning status is not supported on Management SVLANs.

-> ethernet-service svlan 120-150 source-learning disable

-> ethernet-service ipmvlan 320-350 source-learning disable

Release 6.4.2; command introduced.