Alcatel-Lucent 6850-48 硬件手册
Installing and Managing Power over Ethernet (PoE)
Power over Ethernet Specifications
OmniSwitch 6850 Series Hardware Users Guide
September 2009
page 3-3
Power over Ethernet Specifications
The table below lists general specifications for Alcatel-Lucent’s Power over Ethernet support. For more
detailed power supply and Power Source Equipment (PSE) specifications, refer to
detailed power supply and Power Source Equipment (PSE) specifications, refer to
IEEE Standards supported
IEEE 802.3af DTE Power via MDI
Default PoE administrative status
Enabled
Default PoE operational status
Disabled (PoE must be activated on a switch-
by-switch basis via the
by-switch basis via the
com-
mand.)
OmniSwitch 6850 Series platforms supporting PoE
OmniSwitch 6850-P24,OmniSwitch 6850-
P24L, OmniSwitch 6850-P24X, OmniSwitch
6850-P48, OmniSwitch 6850-P48L, and
OmniSwitch 6850-P48X
P24L, OmniSwitch 6850-P24X, OmniSwitch
6850-P48, OmniSwitch 6850-P48L, and
OmniSwitch 6850-P48X
Cable distances supported
100 meters (approx.)
Total number of PoE-capable per switch
48
Default amount of inline power available for each port 15400 milliwatts
Range of inline power allowed for each port
Range of inline power allowed for each port
3000–18000 milliwatts
PoE Current draw
Approximately 4.3 Amps
Default amount of PoE power per slot
Approximately 390 Watts when 510w power-
supply is used and 240 Watts when 360w is
used
supply is used and 240 Watts when 360w is
used
Range of PoE power per slot
360W power supply - 37W to 240W
510W power supply - or 37W to 390W
510W power supply - or 37W to 390W