Alcatel-Lucent 6850-48 硬件手册

Booting OmniSwitch 6850 Series Switches

OmniSwitch 6850 Series Chassis and Hardware Components

page 2-66

OmniSwitch 6850 Series Hardware Users Guide

For information on booting stand-alone switches and switches in stacked configurations, refer to the 
sections below.

The OmniSwitch 6850 Series switch does not use an on/off switch. The power cord is the switch’s only 
connect/disconnect device. The power connector socket is located on the switch’s rear panel. For more 
information, refer to

To boot the switch, plug the power cord (provided) into the power connector socket at the switch’s rear 
panel. Next, plug the power cord into an easily-accessible power source, such as a grounded AC outlet or 
an Uninterruptible Power Supply (UPS).

The switch immediately begins the boot process. Allow a few moments for the switch to boot completely, 
then verify the status of all LEDs on the switch’s front panel. A successful boot for a stand-alone switch 
displays the following LED states:

If any of the LED state differs from the states shown in the table above, refer to

 

for more infor-

mation. Contact Alcatel-Lucent Customer Support if the LED state persists.

For information on logging in and configuring your OmniSwitch 6850 Series switch, refer to the 
OmniSwitch 6850 Series Getting Started Guide and OmniSwitch 6800/6850/9000 Series Switch Manage-
ment Guide.

OK

Solid green

PRI

Solid green

PWR

Solid green

BPS

Solid amber if BPS attached is failed and off when no operational 
backup power supply (BPS) is attached; solid green if an operational 
BPS is attached and operating normally. 

XFP1

Off (applies to all OmniSwitch 6850 Series switches except for 
OmniSwitch 6850-24X, OmniSwitch 6850-P24X, OmniSwitch 6850-
U24X, OmniSwitch 6850-48X, and OmniSwitch 6850-P48X). See 

tion.

XFP2

Off (applies to all OmniSwitch 6850 Series switches except for 
OmniSwitch 6850-24X, OmniSwitch 6850-P24X, OmniSwitch 6850-
U24X, OmniSwitch 6850-48X, and OmniSwitch 6850-P48X). See 

for more informa-

tion.

Slot Indicator

1–8 (non-blinking), depending on the slot number value in the 
boot.slot.cfg file. The default value is 1.