Rotel rdv-1060 用户指南

Speaker Setup

The SPEAKER SETUP PAGE provides setup items
relating to surround sound and bass manage-
ment of the audio signals at the analog out-
puts of the RDV-1060.

: These settings apply only to audio sig-

nals at the analog outputs. They have no ef-
fect on the digital audio output of the
RDV-1060. In addition, these settings only
apply to Dolby Digital and DTS recordings.

Many of the settings on this screen configure
the number and type of speakers in the sys-
tem. Specifically, there are LARGE and SMALL
settings that determine whether deep bass is
reproduced by the speaker connected to a
channel or redirected to a powered subwoofer.
The LARGE setting is “full-range”; the speaker
will reproduce the entire signal including deep
bass recorded in its channel. The SMALL set-
ting is “high-pass”; the speaker will reproduce
only frequencies above the crossover point
(100Hz). Bass below the crossover will be
routed to a powered subwoofer connected to
the RDV-1060.

In addition, there are settings for delaying the
signal to the center or surround speakers and
a test tone option that provides a pink noise
tone for setting the level controls for each
channel on the external processor.

To reach the SPEAKER SETUP PAGE, use
the CURSOR 

 buttons to highlight the

SPEAKER SETUP line on the MAIN PAGE. Then,
press the PLAY/ENTER   button.

To return to the MAIN PAGE, use the CUR-
SOR 

 buttons to scroll down and highlight

the MAIN PAGE line. Then, press the PLAY/
ENTER   button.

The following instructions describe each ad-
justment item on the SPEAKER SETUP PAGE
and the available settings. The default settings
for each item are shown in the illustration.