Monroe 7130 用户指南

 

 
For use on 7130/7140/7150 

Changing the Ribbon Cartridge 

 

 

 

 
1.  Remove excess paper tape. 
2. 

Remove the printer cover.  (Note how ribbon 
feeds, around guides and between print 
wheels and platen; black band up).

 

 

 

3.  Lift out cartridge by moving the lever to the 

center; then move and lift out cartridge. 

4. 

Holding new cartridge over spindles with black 
band up and exposed portion of ribbon on side 
nearest print wheels, place cartridge on 

spindle and engage cartridge…

 

 

 

5.  Replace printer cover. 
 
 

 

 

1.  Remove excess paper tape. 
2. 

Remove the printer cover.  (Note how ribbon 
feeds from outside of spools, around guides 
and between print wheels and platen, black 
band up.) 

 

3.  Lift out spool that is not engaged by lever; 

then move lever aside and lift out other spool. 

4.  Holding new spools over spindles with black 

band up and exposed portion of ribbon on side 
nearest print wheels, place one spool on 
spindle not engaged by lever.  Rotate spools to 
be sure its pins engage in spindle gear. 

5.  Thread ribbon around guides and between 

print wheels and platen. 

6.  Install other spool and rotate to engage 

spindle gear and also to take up slack in 
ribbon. 

7. 

Replace printer cover. 

 
 

To ensure ease of installation, read the instructions 
completely before installing a new paper roll.  Then 

follow the instructions step-by-step. 
1.  Tear off excess paper at the tear-off knife. 
2. 

To remove cover, place thumbs on serrated 
surfaces located on each side of the cover.  
Pressing down with your thumbs, slide the top 
cover toward the back of the calculator.  Once 
the cover has been pushed back approximately 
1”, lift the cover off. 

 

 

3.  Lift up and remove old paper roll from the 

paper roll holders.  Tear off paper between the 
used paper roll and the printer.  Pull remaining 
paper through the printer by continuously 
lifting the leading edge (nearest display). 

 

 

4.  With the leading edge of the new paper roll, 

feeding from the bottom, place the new roll 
into position between the two flexible paper 
roll holders. 

 

 

5.  Feed the paper into the rear of the printer 

mechanism until it meets resistance 
(approximately 1 to 1.5 inches).  Depress the 
paper advance button until the paper extends 
several inches beyond the printer mechanism. 

 

 

 

6.  Feed the paper through the opening of the 

tear-off knife and lay top cover flat on the 
calculator leaving a 1” overhang at the back 

of the top cover.  Apply a firm downward 
and forward pressure, slide the top cover 
forward until it snaps into position. 

7.  Tear off any excess paper. 
 
 
 
 
 

Storage Compartment