RCA dxd416re 用户指南

In order for the receiver and VCR to communicate, you need to attach the
VCR Controller to the back of the receiver.

1.

Plug the VCR Controller into the VCR CONTROL jack on the back of the
receiver.

2.

Affix the other end to the remote sensor on your VCR.

The VCR Controller must be affixed directly over the infrared remote sensor
on your VCR.

Some VCRs have a label that identifies the infrared remote sensor, and
others do not. If the IR sensor is labeled on your VCR, affix the VCR controller
directly over the sensor.

For VCRs that do not label the remote sensor, you need to use the VCR’s
remote to locate the sensor before affixing the VCR controller.

1.

Hold the VCR’s remote control so that it is touching the front
of the VCR.

2.

Slowly move the remote over the front of the VCR while pressing the
remote power button on and off.

3.

When your VCR turns off or on, you have located the sensor.

To test the VCR controller, use a piece of clear tape to temporarily attach the
VCR controller to the spot where you think the sensor is located, and then
follow the steps described under “Selecting a VCR Type.”

You need to tell the receiver which VCR brand you are using.

1.

Press MENU on the remote to bring up the Main menu.

2.

Point to Options and press OK.

3.

Point to System Options and press OK.

4.

Point to Set VCR Type and press OK.

REMOTE SENSOR

Front of VCR

Back of Receiver

SATELLITE IN

OUT

TO
TV

S-VIDEO

VIDEO

R

L

AUDIO

LOW

SPEED

DATA

VCR

IN

FROM

ANT

PHONE JACK