RCA vrm420 用户指南

The CH 3/4 switch on back of the VCR determines what channel the TV must be tuned
to see the VCR’s image. Choose whichever channel is not used locally in your area.

Note: If you connected components using A/V jacks and cables, the VCR’s signal must be
viewed using the TV’s Video Line Input. To find the Video Line Input, refer to the manual
that came with the TV or see Finding the TV’s Video Line Input on page 47 in the Other
Information section of this manual.

Match the wide blade of the power cord to the wide slot in the AC outlet. Be sure to
insert the plug completely.

1.

Remove the battery compartment cover on the remote control.

2.

Insert new batteries matching the polarities (+ and –) on the batteries with
the diagram in the battery compartment.

3.

Put the battery compartment cover back on the remote.

Turn on the TV and press the VCR button on the remote control to turn
it on.

Note: If you have an RCA, GE, or Proscan TV, your VCR’s remote control
may be able to operate it without being programmed. Press the TV
button on the remote control and then the ON•OFF button. If neither one
turns on the TV, see Using the Remote Control starting on page 25 for
details about programming the remote control to operate other brands
of TVs.

Tune the TV to the VCR viewing channel. The VCR viewing channel is
channel 3, 4, or the TV’s video line input.

•

If you connect your VCR using RF coaxial cable only, turn the TV to
channel 3 or 4 (whichever was set on the CH 3/4 switch).

•

If you connected the VCR using A/V jacks and cables, select the TV’s video
line input. For more information see Finding the TV’s Video Line Input  on
page 47 in the Other Information section of this manual.