RCA vrm420 用户指南

•

Connect all components before plugging any power cords into the wall outlet.

•

Always turn off the TV and other components before you connect or disconnect any cables.

•

Insert all cable plugs firmly into their jacks.

•

Place any Audio/Video (A/V) cables to the side(s) of the TV’s back panel instead of straight
down the back after connecting components.

•

Try not to coil any twin-lead cables and keep them away from all A/V cables as much as
possible.

•

Make sure all antennas and cables are properly grounded. Refer to the Safety Tips  sheet
packed with your unit for detailed information.

•

Never block ventilation slots in any component. Arrange the components so that air can
circulate freely.

•

Do not stack components.

•

Allow adequate ventilation when placing components in a stand.

•

Place an amplifier or satellite receiver on the top shelf of a stand so heated air rising from it
will not flow around other components.

The RF coaxial cable supplied with your VCR carries both sound and picture information.
This is the cable used in all connection diagrams in this chapter.

If your TV has A/V input jacks, you should use A/V cables (not supplied) to connect the
VCR to the TV. A/V cables provide better picture and sound quality than an RF coaxial
cable. If you would like to hook up your VCR using A/V cables, refer to the Advanced
Connection information on page 48 in the Other Information chapter of the manual.