Printronix L5020 用户手册
Chapter 3
Printer Configuration
86
NOTE: For most applications, the default settings for font memory
are acceptable. Therefore, do not change the defaults
unless your application requires an uncommon font
memory configuration.
unless your application requires an uncommon font
memory configuration.
Activating Font Memory Options
After selecting any of the “Font Memory” options, perform the
following steps to activate the new value:
following steps to activate the new value:
1.
Save your configuration changes. See the Config. Control
menu option “Save Configuration” on page 63.
menu option “Save Configuration” on page 63.
2.
Change the power-up configuration to match the configuration
you just saved. See the Config. Control menu option “Power-up
Configuration” on page 64.
you just saved. See the Config. Control menu option “Power-up
Configuration” on page 64.
3.
Turn the printer power off and then on again.
Max Char Memory
The Maximum Character Memory option specifies the size of the
largest character that can be printed. To calculate the memory
requirement, use this equation:
largest character that can be printed. To calculate the memory
requirement, use this equation:
For example, if an application requires a character that is 7 inches
high by 4 inches wide, calculate the Maximum Character Memory
value as follows:
high by 4 inches wide, calculate the Maximum Character Memory
value as follows:
Therefore, select a value that is equal to or greater than 315,000.
The closest available value is 350 KBytes.
The closest available value is 350 KBytes.
The allowable range is 50 KBytes to 900 KBytes, in 50-KByte
increments. The default value for this parameter is 300 KBytes.
increments. The default value for this parameter is 300 KBytes.
horizontal
resolution
x
vertical
resolution
character
height (inches)
character
width (inches)
x
x
8
300
x
300
4
x
x
8
7
= 315,000