Printronix SL5000 参考手册
180
Chapter
6
Configuring the Epson FX-1050 Emulation with Control Codes
Graphics, Quadruple Density
ASCII Code ESC Z
n1 n2
Hex Code
1B 5A
n1 n2
Dec Code
27 90
n1 n2
Purpose
Selects Quadruple Density Bit Image graphics of 240 dpi
horizontally and 72 dpi vertically.
horizontally and 72 dpi vertically.
where:
(
n1 + 256n2) defines the number of data bytes to follow.
DATA = ASCII characters for the dot pattern bytes.
NOTE: The DATA can be expressed in a format with the appropriate decimal
values of the ASCII characters supplied, especially in cases where
the dot patterns of nonprintable characters are required.
the dot patterns of nonprintable characters are required.
“DATA” consist of 8-bit dot columns, with the MSB at the top,
and “1” bits producing dots. For more information, refer to
Chapter 8, “Graphics.”
and “1” bits producing dots. For more information, refer to
Chapter 8, “Graphics.”
Comment
This mode is similar to ESC L, except that four dot columns are
printed in the space normally taken by two columns. You can
change graphics density with the ESC ? command.
printed in the space normally taken by two columns. You can
change graphics density with the ESC ? command.
Example
The following example produces quadruple density graphics of
the pattern used in the standard density example. The amount of
data must be quadrupled for quadruple density (the data are
used 108 times rather than 27).
the pattern used in the standard density example. The amount of
data must be quadrupled for quadruple density (the data are
used 108 times rather than 27).
Half Speed Mode, On/Off
ASCII Code ESC s
n
Hex Code
1B 73
n
Dec Code
27 115
n
Purpose
Reduces printer speed 50%
where:
n = hex 00 or 30 turns half speed mode off
n = hex 01 or 31 turns half speed mode on
n = hex 01 or 31 turns half speed mode on
†
Comment This command is ignored.