Innotech surfboard 快速安装指南

 

 

Universal Remote Control Quick Start Guide

 

 

Following are highlights for the operation of the SurfBoard remote control.  To take full advantage of the unique 
SurfBoard features, we strongly suggest you take a few minutes to browse through the SurfBoard User

=s Guide. 

 

 

 
Step 1: Insert 4 AAA batteries.  The  SurfBoard remote 
control will say “hello” to show it is functioning. 

 
 

 

 
Step 2: Set up the SurfBoard for your TV using automated 
setup.  The unique SurfBoard 

[HELP] button allows you to 

program the remote without having to go though the 
complicated programming procedures of other universal 
remote controls.  Just press the 

[HELP] button located on 

the  bottom of the remote.  SurfBoard will then give you 
helpful choices.  If at any point you want to hear the choices 
again just press 

[HELP] again. A complete list of all of the 

prompts available in the help system is listed in the user 
guide. 
 

Press 

[HELP] and listen to the choices: 

 

You can exit the help system by pressing the PROG button or 
waiting for 15 seconds. 
 

 

 

Step 3: Press 

[1]. The  SurfBoard will respond with the 

following options: 

To search for your TV press 1 
To program a TV from the device list press 2 

 
Step 4: Press 

[1]. The SurfBoard will respond with: 

 
To search for your TV by brand, enter the 2 digit brand code on 
the back of this quick start guide. For example if you have a 
Sony TV, type in 

[5][9].   If your brand is not listed, press 

[MUTE/ENTER] to search through all TVs. 

 

The  SurfBoard will say, 

Asearching for TVs.@  You will hear 

the 3 digit device code for each TV code it tries before sending 
out the power code.  After each code is sent, it will wait 4 
seconds for you to respond before trying the next code.   
 
Step 5:  When your TV turns off, press any front button except 
[SHIFT] to save the code. 
 
If your brand of TV is not listed, you can search through all the 
TV codes.  For alternate set up methods including learning 
codes from your original equipment remote, please see the 
Users Guide. 
 

 

 

Step 6. Using the same method you used to set up your TV, 
you can set up the SurfBoard remote to control your cable or 
satellite box.  The sequence for setting up your cable or 
satellite box by searching just your brand of cable or satellite 
box is 

[HELP] 

ÿ

 

[2] 

ÿ

 

[1] 

ÿ

 

[2_digit_brand_code] 

The sequence for searching through all cable and satellite 
receivers is  

[HELP] 

ÿ

 

[2] 

ÿ

 

[1] 

ÿ

 

[MUTE/ENTER]

 

 

Since some cable and satellite boxes have no power button, 
the  SurfBoard will send a channel-up command when 
searching for cable or satellite boxes.