Toshiba rs-tx20 用户指南

S e t u p   4 :   C a b l e   B o x   a n d   S a t e l l i t e   B o x

Make sure the cables from the wall are connected to your cable and satellite boxes. 

Connect a Composite A/V cable from the Audio/Video Output jacks on the satellite 
box to the Audio/Video Input 1 jacks on the back of the DMS.

Connect a Coaxial RF cable from the RF Out jack on the cable box to the 
Cable/Antenna-RF In

 jack on the DMS.

Connect a Composite A/V cable from the Audio/Video Output jacks on the DMS to 
the Audio/Video Input jacks on your TV. 

Connect the phone cord (see page 8). After you complete Guided Setup, you can 
connect your DMS to a home network and use a broadband Internet connection instead 
of a phone line to connect to the TiVo service. See Chapter 8. 

 First, see page 5 to check 

whether you can use the Serial Control cable for either your 
satellite or cable box. If you can, connect it as shown in the 
diagram to the right. Then use the IR Control cable for the 
other box. If you can’t use the Serial Control cable for 
either box, you can use the IR control cable for both. See 
the IR diagrams at the right.

Plug in all power cords and turn on your TV. 
Set your TV to display video from the input jacks you used in step 

. You may have 

to find the correct TV input setting by pressing the Input or TV/Video button on your 
TV’s remote control until you see the Welcome screen. (For more help, see page 131.)

Once you see the Welcome screen, you’re ready to complete Guided Setup. If you need 
help, see Chapter 2.

 Plug the purple end of the IR Control cable into 

the Control Out-IR connector (the lower mini-jack) 
on the DMS. 

 Locate the IR sensor (see page 6 for 

help). 

 Mount the IR emitters. Place one emitter 

on top of the cable/satellite box and the other 
underneath it. Be sure both emitters stick out about 
1.5 inches directly in front of the IR sensor. Use the 
provided adhesive strips to hold the emitters in place.

Follow steps 

and

 as above. In step

, 

mount the IR emitters on top of each box as shown.

®

®