Toshiba tdp-wx5400u 用户指南

When the lamps are replaced, the filters should also be replaced, not cleaned.

Refer to the following guide to replace the filters.

replace the filters. Doing so could injure your hand or fingers.

•

The side and the rear filters can be pulled out from 

the slots located  at the bottom as shown.

1

4

When  dirt  and  dust  build  up  in  the  filter,  the  air  circulation  inside  the  projector  is 

affected and the internal temperature will rise, causing the projector to stop working or 

malfunction.

Be sure the filter is inserted all the way into the slot. Leaving gaps will allow dust and 

dirt to get inside the projector again.

When you purchase a new lamp, new filters are also provided. If a filter is torn or dirty, 

please replace with new one. Continuing to use a ripped filter will allow dust and dirt to 

get inside the projector.

Never run the projector with the filters removed. It is recommended that you clean the 

•

•

•

•

•

After replacing the filters, the filter time counter should be reset to zero. Refer to the 

following guide:

1

 Press the p or q button to move to the [Reset] menu and press Enter.

 Select [Clear filter time] using p or q and press Enter.

4

 Select OK using t or u and press Enter to reset the filter time to zero.

