Toshiba tlp-xd2000u 业主指南

41

40

■ The default setting menu

This menu shows placement status and other settings.

Description

Item

Set the time to wait for the power to be turned off after the last 
operation is made with no input signal. 

Set whether the input with signals is only selected or not. 

Beep when operation is made.

Sets whether to turn on the power when the ON/STANDBY button is 
pressed (Manual), or when the power cord is plugged in (Auto).  

Sets the lamp power.                                   

Off (not turned off)            30 min.

Detailed description
[Auto input search]

[On]: Automatically searches the signals that

can be projected, and switches input
from the connected device that outputs
the video signals each time the INPUT
button is pressed. The input from the
connected device that outputs no video
signals is skipped.

[Off]: Displays the Input select menu.

Toggle with 

 

 buttons and press 

button. (The input without signals can be
selected.)

[Power on]

Note that if [Power on] is set to [Auto], then if the power is supplied when restored
after a power outage, the projector will come on.

[Lamp power]

When [Lamp power] is set to [Low], the screen becomes a little darker, but the
cooling fan noise gets quieter.

Description

Item

Sets projection mode in accordance with Placement Style. 

Sets the cooling fan speed.

Lock the control panel buttons. 
[      or      : Enter setting mode]      [           : Select On/Off]       
[     :Confirm]      [           :Select OK to end]   
Press [Cancel] to return.

Press       . (The password and user logo are not reset.) 
Resets all adjustments and settings to their factory settings. 

Password setting

(Rear ceiling)

(Standard)

(Rear)

(Ceiling)

Detailed description
[Fan mode]

Setting [Fan mode] to [High] increases the cooling fan speed. (The cooling fan
noise gets louder.) Set this option to use the projector, for example, at high altitude
(over 1,500 meters above sea level).
• Do not set Fan mode to [High] when using the projector at a lower altitude.

[Key lock]

Protect from operating errors by locking on the control panel buttons of the
projector. (The remote control operations are available.)
Control panel operations are locked after the setting is done, and accordingly
operation with the control panel buttons is disabled.
• To release the key lock, set the [Key Lock] to [Off] using remote control. Pressing

the [RETURN] button on the projector for 10 seconds also sets the [Key Lock] to
[Off]. (When operating the main unit, the 2 indicators of LAMP and TEMP light in
orange for 3 seconds, and at the same time the projector beeps.)

    /    shows whether signal is 
 input or not.