Toshiba mw20fn3 用户手册

下载
页码 68
13
Introduction
Operation:
• Aim the remote control at the remote sensor and press control buttons to
operate.
• Operate the remote control within 30
°
 angle on either side of the remote
sensor, up to a distance of Approx. 7 meters.
Replace the compartment
cover.
Install two “AAA” batteries
(supplied), paying attention to the
polarity diagram in the battery
compartment.
Slide the battery compartment
cover in the direction of the
arrow.
Approx. 7 meters
Battery precautions:
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re-
versed batteries may cause damage to the device.  To avoid a potential short circuit, insert the “–” end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer’s directions.)
• Press POWER to turn the unit on or off.
• Select your desired operating mode (TV/VCR or DVD) using TV/VCR or DVD.
• Tap CH   or CH   to move through the channels one channel at a time.
• The Direction buttons ( / /
/
) are also used to navigate on-screen menu system.
• You can directly access specific channels using Direct channel selection buttons.
1
2
3
Inserting Batteries
Remote control basics
 5F10201C (E)p02-13
5/6/03, 16:50
13