Netopia 3346N-ENT 用户指南
Virtual Private Networks (VPNs) 5-9
When you define a Connection Profile as using L2TP by selecting L2TP as the datalink encapsulation method,
and then select Encapsulation Options, the L2TP Tunnel Options screen appears.
and then select Encapsulation Options, the L2TP Tunnel Options screen appears.
•
Enter the L2TP Partner IP Address. This specifies the address of the other end of the tunnel.
If you do not specify the L2TP Par tner IP Address the Router cannot initiate tunnels.
•
If you specify the L2TP Par tner IP Address, and the address is in the same subnet as the Remote IP
Address you specified in the IP Profile Parameters, the Tunnel Via Gateway option becomes visible. You
can enter the address by which the Router par tner is reached.
Address you specified in the IP Profile Parameters, the Tunnel Via Gateway option becomes visible. You
can enter the address by which the Router par tner is reached.
If you do not specify the L2TP Par tner IP Address, the Router will use the default gateway to reach the
par tner and the Tunnel Via Gateway field is hidden. If the par tner should be reached via an alternate por t
(i.e. the LAN instead of the WAN), the Tunnel Via Gateway field allows this path to be resolved.
par tner and the Tunnel Via Gateway field is hidden. If the par tner should be reached via an alternate por t
(i.e. the LAN instead of the WAN), the Tunnel Via Gateway field allows this path to be resolved.
•
Toggle L2TP Tunnel Authentication to No or Yes.
If you set authentication on the tunnel, an editable Pass-phrase field appears where you can specify a
password between eight and 15 characters long.
password between eight and 15 characters long.
•
From the pop-up menu select a PPP Authentication protocol for the PPP connection. Options are PAP, or
CHAP. The default is PAP. The authentication protocol must be the same on both ends of the tunnel.
CHAP. The default is PAP. The authentication protocol must be the same on both ends of the tunnel.
•
You can specify a Data Compression algorithm, either None or Standard LZS, for the L2TP connection.
•
You can specify a Send Host Name which is used with Send Secret for authenticating with a remote PNS
when the profile is used for initiating a tunnel connection.
when the profile is used for initiating a tunnel connection.
•
You must specify a Send Password (or Secret, the CHAP term for password), used for authenticating the
tunnel when initiating a tunnel connection.
tunnel when initiating a tunnel connection.
•
You can specify a Receive Host Name which is used with the Receive Secret for authenticating a remote
L2TP client.
L2TP client.
•
You must specify a Receive Password (or CHAP Secret), used for authenticating the remote L2TP client.
L2TP Tunnel Options
L2TP Partner IP Address: 0.0.0.0
L2TP Tunnel Authentication: No
PPP Authentication: PAP
Data Compression... Standard LZS
Data Compression... Standard LZS
Send Host Name:
Send Password:
Receive Host Name:
Receive Password:
Send Password:
Receive Host Name:
Receive Password:
Initiate Connections: Yes
On Demand: Yes
On Demand: Yes
Idle Timeout (seconds): 300
Enter an IP address in decimal and dot form (xxx.xxx.xxx.xxx).