Mitsubishi WS-55517 用户手册

This screen allows the TV to learn the connection 

between device(s) and input(s).  Inputs 1-3, 

Components 1 & 2, and/or the inputs for the A/V 
Receiver all need to be checked, if connected.  Add 
or remove check marks to indicate what type of 
connections (Audio, Video or Both) are used with each 

TV and A/V Receiver input.

Note:  Video inputs to the A/V Receiver are 
normally used to transfer signals to the line input 
of a VCR for recording.  Mitsubishi recommends 
leaving Video unchecked.  If your VCR inputs 
are connected to TV outputs Audio Video 1, then 
you do not need to connect video to your A/V 
Receiver.

Select the VCR you would like to use for recording.  You 

may also select whether you want the recorded 16:9 
signals from digital channels or IEEE-1394 devices to be 

cropped (sides are cut off) or Anamorphic (full screen).  
If Anamorphic is selected for viewing, choose the 
Standard format for the best quality playback.

The RF Connection screen displays only when 

adding or changing a cable box.  If your cable box 
is connected to a TV Antenna input, check the RF 
checkbox.  Select the TV antenna input that is used 
with the cable box  Select the channel number used for 
output by your cable box.  The default channel is 003. If 
the cable box is also connected to a VCR for recording, 
select that VCR.  

If your cable box is connected using Audio/Video 
cables, make sure the RF checkbox is unchecked.  

Then the next screen will be Connection (Figure 19), to 

allow the selection of the TV input used with the cable 
box.   

This screen only displays if an added device has the 

same IR code as a previously added device of the 
same type and manufacturer.  You can specify the IR 
setting for the new device.  For example, for the second 
Mitsubishi VCR you can specify the IR Code setting to 

VCR-B, if the primary  Mitsubishi VCR is using the VCR-
A IR code.