Champion pp-3 用户手册
C O N T R O L P A N E L S
Off State
This state is active after filling up the tank with water and pressing the STOP key following
the POWER UP state. This is also the state that becomes active whenever the Stop key is
pressed during a wash cycle.
the POWER UP state. This is also the state that becomes active whenever the Stop key is
pressed during a wash cycle.
In this state the Heater is working at very low power, trying to detect a possible dry-fire (i.e.
an empty tank). The 1
an empty tank). The 1
st
line of the display indicates O F F and the 2
nd
line the current water
temperature. All cycle LED’s are also flashing, indicating that they can be pressed. Pressing
one of the Cycle keys starts the corresponding cycle and enters the WASH state.
one of the Cycle keys starts the corresponding cycle and enters the WASH state.
From this state, the cycle programming and low-level programming menus are accessible
with the proper key sequence.
with the proper key sequence.
Wash State
This is the “normal” operating mode. Pressing any of the 5 cycle keys will start the
corresponding cycle. The 1
corresponding cycle. The 1
st
line of the display toggles the scrolling cycle’s name and the
remaining cycle time (all cycle steps duration added together). The 2
nd
line of the display
shows the current water temperature.
While in Wash mode, the selected cycle LED is full on to indicate that the cycle is active.
The Soap status LED is active if needed, as well as the Heater status LED. The Pump LED
group is functional according to the current Water Pump speed.
The Soap status LED is active if needed, as well as the Heater status LED. The Pump LED
group is functional according to the current Water Pump speed.
Pressing the Up/Down keys will light the Up/Down LED’s, and the current temperature
information is replaced by the set point temperature. The Up/Down keys allow this value
to be changed between 100° and 125°F (37° to 52°C). If no key is pressed for 5 seconds,
the display reverts to the current water temperature and the Up/Down LED’s shut off. The
new temperature will be stored until the next water change. After a drain/fill sequence, the
cycle temperatures programmed are used again.
information is replaced by the set point temperature. The Up/Down keys allow this value
to be changed between 100° and 125°F (37° to 52°C). If no key is pressed for 5 seconds,
the display reverts to the current water temperature and the Up/Down LED’s shut off. The
new temperature will be stored until the next water change. After a drain/fill sequence, the
cycle temperatures programmed are used again.
The cycle may be stopped by pressing the Stop key (at which point the Off state becomes
active). Pressing the current cycle’s key will pause the wash (timer freezes, and all outputs
are off, except the Heater) and the cycle LED will flash. Line 1 of the display then blinks
active). Pressing the current cycle’s key will pause the wash (timer freezes, and all outputs
are off, except the Heater) and the cycle LED will flash. Line 1 of the display then blinks
P A U S E
. Line 2 still shows the current water temperature. Re-pressing the cycle key
resumes the wash cycle where it left off.
Pressing a cycle key other than the current cycle’s restarts the machine in the new selected
cycle, with new soap amounts added if necessary.
cycle, with new soap amounts added if necessary.
When a cycle is finished, the buzzer sounds according to Buzzer Time, and the system goes
into the Hold/Clean state.
into the Hold/Clean state.
32