Sony STR-DA3400ES 用户指南
120
US
D:\Cannes\STR-DA3400ES_U_R1\3289137121\3289137121\3289137121\01US-
STRDA3400ESUC\100REM.fm
STRDA3400ESUC\100REM.fm
masterpage: Left
STR-DA3400ES
3-289-137-12(1)
3-289-137-12(1)
3
Turn on the amplifier in zone 2.
4
Press one of the input buttons
(except PHONO, MULTI IN, TV
and HDMI1-4) on the remote to
select the source signals you
want to output.
(except PHONO, MULTI IN, TV
and HDMI1-4) on the remote to
select the source signals you
want to output.
For zone 2, analog video and audio
signals are output. When you select
SOURCE, the signals of the current input
are output.
signals are output. When you select
SOURCE, the signals of the current input
are output.
5
Adjust to a suitable volume.
• In the case of illustration 1-1
(page 104), you can only adjust the
surround back speaker volume in
zone 2.
Adjust the volume using MASTER
VOL +/– on the remote.
surround back speaker volume in
zone 2.
Adjust the volume using MASTER
VOL +/– on the remote.
• In the case of illustration 1-2
(page 104), adjust the volume using the
receiver of zone 2.
receiver of zone 2.
Tips
• Even when this receiver is in standby mode (press
?/1 on the remote to turned off this receiver), the
receiver in zone 2 remains turned on. To turn off all
receivers, press ?/1 and AV ?/1 on the RM-
AAL017 remote at the same time (SYSTEM
STANDBY).
receiver in zone 2 remains turned on. To turn off all
receivers, press ?/1 and AV ?/1 on the RM-
AAL017 remote at the same time (SYSTEM
STANDBY).
• Only signals from components connected to the
analog input jacks are output through the ZONE 2
jacks. No signals are output from components
connected to only the digital input jacks.
jacks. No signals are output from components
connected to only the digital input jacks.
• When SOURCE is selected, the signals input to the
MULTI CHANNEL INPUT jacks are not output
from the ZONE 2 OUT jacks even when the multi
channel input is selected. The analog audio signals
of the current function are output.
from the ZONE 2 OUT jacks even when the multi
channel input is selected. The analog audio signals
of the current function are output.
Operating each
component using the
remote
component using the
remote
When you program the remote to control the
following Sony or non-Sony components, you
can use the buttons on the remote that are
marked with circles. Note, however, that some
buttons may not operate your component.
If you want to change the contents of the input
list to match your particular components, see
“Programming the remote” (page 122).
following Sony or non-Sony components, you
can use the buttons on the remote that are
marked with circles. Note, however, that some
buttons may not operate your component.
If you want to change the contents of the input
list to match your particular components, see
“Programming the remote” (page 122).
Using the Remote