Dialogue a33i 用户指南
86
The GPRS/CDMA module does not work properly
1.
Make sure the GPRS/CDMA module is available in your FlyBook.
You must apply for a GPRS/CDMA account and get a SIM card
from your network service provider for the module to operate.
from your network service provider for the module to operate.
2.
Make sure the SIM card is properly inserted into the SIM card slot.
3.
Make sure that the correct software driver is installed and an initial-
ization command has been input in the Extra initialization com-
mands input box.
ization command has been input in the Extra initialization com-
mands input box.
The Wireless LAN cannot connect to the network
1.
An incorrect network name (SSID) or network key may be used.
Make sure you have set the network name (SSID) and network key
to the same values as the access point (infrastructure connection)
or the computers to be connected with (Ad Hoc connection).
to the same values as the access point (infrastructure connection)
or the computers to be connected with (Ad Hoc connection).
2.
The FlyBook may be placed too far from other communication
devices. Retry the connection after moving the FlyBook closer to
the computers to be connected with (Ad Hoc connection) or to the
access point (infrastructure connection). Also, check the wave con-
dition in the Wireless Network Connection Status window.
devices. Retry the connection after moving the FlyBook closer to
the computers to be connected with (Ad Hoc connection) or to the
access point (infrastructure connection). Also, check the wave con-
dition in the Wireless Network Connection Status window.
3.
Check if the wireless LAN is turned on. Verify that Disable Radio is
not checked in the Network setting window.
4.
Make sure you have access rights or Network authentication to the
network you want to connect to.
network you want to connect to.
5.
Try changing channels to avoid active channel duplication.
6.
Check the setting of the protocol, work group, shared setting, and IP
address.