Roland F-50 业主指南
7
Introduction
4.
Stand the instrument back up.
When lifting the instrument back up, grasp near the
center of the F-50, and gently raise the instrument.
center of the F-50, and gently raise the instrument.
fig.st03-2
If the Stand is Uneven
If after lifting the F-50 back up you find that stand is
crooked, try loosening the screws and then securing
them again. When retightening, start with the top
screws, then work your way down. When doing this,
slightly loosen the screws before firmly tightening them.
crooked, try loosening the screws and then securing
them again. When retightening, start with the top
screws, then work your way down. When doing this,
slightly loosen the screws before firmly tightening them.
5.
Place the caps over the heads of the screws (four
on each side).
on each side).
fig.st03
When Moving the Instrument
Disconnect the AC adaptor, cables and the music stand from
the F-50.
the F-50.
Then lift the piano while keeping it level, and move it with
care, so that you do not drop it on your feet, or get your
hands caught.
care, so that you do not drop it on your feet, or get your
hands caught.
When Disassembling
Disassemble the unit by carrying out assembly Steps 1-5 in
reverse order.
reverse order.
Caps
F-50_e.book 7 ページ ２００５年２月２日 水曜日 午後５時１１分