Roland c-280 业主指南

Getting the Most out of the C-280

Using Damper Pedal/Tone Select Pedal

If you connect a separately available pedal switch (such as the DP-6 or DP-2) to the Pedal
jack located on the bottom panel, you will be able to use pedal functions.

fig.04-01

The pedal can perform the following two functions

Damper Pedal

In the same way as the damper pedal of a piano, pressing the pedal will allow notes to
be sustained even after you release your finger from the key.

The damper pedal works only with attenuated Celesta tones.

Tone select pedal

By depressing this pedal, you can select two tones from the tone buttons in the Organ
([Manual]/[R1]/[R2]) and Ensemble sections.

When the power is turned on, the pedal will function as a damper pedal.

■

Using as a Tone Select Pedal

➤

Procedure

Hold down the [Function] button, and press the [Pedal Mode]
button.

The [Pedal Mode] button indicator will light.

fig.04-02

Press the two desired tone buttons in sequence.

This will specify the tones that will be selected.
Each time you press the pedal, you will alternate between these two sounds.
If you press only one button, you will alternate between that tone and the previously
selected tone.
Once again press the [Function] button and the [Pedal Mode] button. The [Pedal Mode]
button indicator will go dark, and you will return to the damper pedal function.

If you perform this procedure, the pedal switch cannot be used as a damper pedal.

Expression

Damper

Pedal

DP-6

MEMO

NOTE

Choir

Celesta

Chimes

R 1

R 2

Manual

Ensemble

Cancel

Organ

Pitch

Baroque

ment

Tempera-

Equal

Werckmeister

Kirnberger

Vallotti

Meantone

Just Major

Pythagorean

Just Minor

Min

Max

Reverb

Demo

Write

Octave Shift

Split

Function

Down

Point

Pedal

Mode

Press the [Pedal Mode] button

While holding down the [Function] button

NOTE