Roland Fantom-Xa 业主指南
129
Recording Songs
8.
Repeat the above steps to continue inputting.
The previous value of each parameter is remembered. This
means that if you want to use the same settings as the
previously input note, there is no need to change the settings.
Once you have set the Gate Time parameter and Input Velocity
parameter, it is not normally necessary to change them, so all
you have to do is set the Step Time parameter and specify the
pitch (note) of each note.
means that if you want to use the same settings as the
previously input note, there is no need to change the settings.
Once you have set the Gate Time parameter and Input Velocity
parameter, it is not normally necessary to change them, so all
you have to do is set the Step Time parameter and specify the
pitch (note) of each note.
The note will not be finalized as long as you hold down the key.
This means that you will be able to modify the various
parameters of the note (Note Type, Gate Time, Input Velo).
This means that you will be able to modify the various
parameters of the note (Note Type, Gate Time, Input Velo).
9.
When you are finished step recording, press [
].
The [
] indicator will go dark.
If you are not satisfied with the results of the previous step
recording, you can press [ERASE/UNDO] to return to the state
prior to recording (Undo/Redo). After executing Undo, you can
use Redo to revert to the previous state. After executing Undo,
you can execute Redo by performing the above procedure once
again.
recording, you can press [ERASE/UNDO] to return to the state
prior to recording (Undo/Redo). After executing Undo, you can
use Redo to revert to the previous state. After executing Undo,
you can execute Redo by performing the above procedure once
again.
Inputting a Chord
Press the chord. The cursor will move to the next step when you
release all keys or pads.
release all keys or pads.
Moving the input location
Pressing [F6 (>)] will move the input location forward by the current
Note Type value.
Note Type value.
Pressing [F5 (<)] will move the input location backward by the
current Note Type value.
current Note Type value.
Moving the display region
Pressing
or
will move the displayed region of notes
upward or downward.
The Relation between Note Value Length
and Gate Time
and Gate Time
The relation between the length of the note value and the gate
time is shown below. Since the Fantom-Xa’s sequencer uses a
TPQN (Ticks Per Quarter Note; i.e., resolution) of 480, a quarter
note gate time is 480 ticks.
time is shown below. Since the Fantom-Xa’s sequencer uses a
TPQN (Ticks Per Quarter Note; i.e., resolution) of 480, a quarter
note gate time is 480 ticks.
The gate time that is recorded in step recording will be the
original gate time value multiplied by the value of the Gate
Time parameter. For example, if the Gate Time parameter
is set to “80%,” inputting a quarter note will mean that the
gate time is 480 x 0.8=384.
original gate time value multiplied by the value of the Gate
Time parameter. For example, if the Gate Time parameter
is set to “80%,” inputting a quarter note will mean that the
gate time is 480 x 0.8=384.
Note
Gate time
30
40
45
60
80
90
90
120
160
180
240
240
320
360
480
640
720
960
1920
3840
3840
Fantom-Xa_e.book 129 ページ ２００４年１０月２２日 金曜日 午後２時３分