Roland Fantom-Xa 业主指南
191
Adding Effects
This is a stereo compressor (limiter) that is applied to the final output of the Fantom-Xa. It has independent high, mid, and low ranges.
Independently for the high-frequency, mid-frequency, and low-frequency regions, this compresses any sounds that exceed the specified level,
making the volume more consistent. When mixing down to MD, or DAT, or when you procedure your own original audio CD, this lets you
master at an optimized level.
Independently for the high-frequency, mid-frequency, and low-frequency regions, this compresses any sounds that exceed the specified level,
making the volume more consistent. When mixing down to MD, or DAT, or when you procedure your own original audio CD, this lets you
master at an optimized level.
*
Mastering effect settings apply to the entire Fantom-Xa. These settings are not for individual patches or performances.
*
The mastering effect is applied to the sound that is output from the OUTPUT A (MIX) jacks. It will not be applied to the sound that is output from the
OUTPUT B jacks.
OUTPUT B jacks.
fig.Mastering
Mastering Effect
Parameter
Value
Explanation
(Type)
00: Hard Comp,
01: Soft Comp,
02: Low Boost,
03: Mid Boost,
04: Hi Boost,
05: User
01: Soft Comp,
02: Low Boost,
03: Mid Boost,
04: Hi Boost,
05: User
Recalls effect settings.
00–04:
Preset settings
05:
User settings
By pressing [F6 (SYSTEM WRITE)] you can save the current settings as user settings.
* Only one set of user settings can be saved.
Split Lo
200–800 Hz
Frequency at which the low-frequency (LO) and mid-frequency (MID) bands are split
Split Hi
2000–8000 Hz
Frequency at which the high-frequency (HI) and mid-frequency (MID) bands are split
Lo/Mid/Hi Level
0–24 dB
Output volume
Low/Mid/Hi Attack
0–100 ms
Time from when the volume goes up the threshold level until the compressor effect applies
Low/Mid/Hi Release
50–5000 ms
Time from when the volume falls below the threshold level until the compressor effect no longer
applies
applies
Low/Mid/Hi Thresh
-36–0 dB
Volume level at which compression begins
Low/Mid/Hi Ratio
1.00:1–INF:1
(INF: infinity)
(INF: infinity)
Compression ratio
About THRESHOLD (Thresh) and RATIO
As shown in the diagram below, these parameters determine
how the volume is to be compressed.
how the volume is to be compressed.
fig.MasterComp.e
1:1
2:1
4:1
INF:1
THRESHOLD
Input Level
Output Le
v
e
l
RATIO
Fantom-Xa_e.book 191 ページ ２００４年１０月２２日 金曜日 午後２時３分