Roland FP-7 用户指南
143
Connecting to a Computer
If you use a USB cable (commercially available) to connect the
USB (MIDI) connector located on the FP-7’s rear panel to the
USB connector of your computer, you’ll be able to do the
following things.
USB (MIDI) connector located on the FP-7’s rear panel to the
USB connector of your computer, you’ll be able to do the
following things.
• Use the FP-7 to play SMF music files played back by MIDI-
compatible software.
• By transferring MIDI data between the FP-7 and your
sequencer software, you’ll be able to enjoy a wide range
of possibilities for music production and editing.
of possibilities for music production and editing.
Connect the FP-7 to your computer as shown below.
fig.cnct-usb2.eps
* Refer to the Roland website for system requirements.
Roland website: http://www.roland.com/
If connection to your computer is
unsuccessful...
Normally, you don’t need to install a driver in order to connect
the FP-7 to your computer. However, if some problem occurs,
or if the performance is poor, using the Roland original driver
may solve the problem.
For details on downloading and installing the Roland original
driver, refer to the Roland website.
Roland website:http://www.roland.com/
the FP-7 to your computer. However, if some problem occurs,
or if the performance is poor, using the Roland original driver
may solve the problem.
For details on downloading and installing the Roland original
driver, refer to the Roland website.
Roland website:http://www.roland.com/
Specify the USB driver you want to use, and then install the
driver. For details, refer to “Changing the USB Driver Settings”
(p. 143).
driver. For details, refer to “Changing the USB Driver Settings”
(p. 143).
1.
Press the [Function] button.
2.
Press the [Reverb] button.
3.
While holding down the [Display] button, use
the [-] [+] buttons to select “USB Driver.”
the [-] [+] buttons to select “USB Driver.”
4.
Press the [-] or [+] button to select the USB
driver you want to use.
driver you want to use.
5.
Turn the power off, then on again.
Connecting to a Computer via
the USB (MIDI) Connector
the USB (MIDI) Connector
USB cable
USB connector
Computer
Changing the USB Driver Settings
Setting
Description
Generic
Choose this if you want to use the standard
USB driver that was included with your
computer.
Normally, you should use this mode.
USB driver that was included with your
computer.
Normally, you should use this mode.
Original
Choose this if you want to use a USB driver
downloaded from the Roland website.
downloaded from the Roland website.
Caution
• To avoid the risk of malfunction and/or speaker
damage, always make sure to turn the volume all the
way down and turn off the power on all equipment
before you make any connections.
way down and turn off the power on all equipment
before you make any connections.
• Only MIDI data can be transmitted and received via
USB.
• A USB cable is not included. If you need to obtain
one, ask the dealer where you purchased the FP-7.
• Switch on power to the FP-7 before you start up the
MIDI application on your computer. Don’t turn the FP-7’s
power on/off while your MIDI application is running.
power on/off while your MIDI application is running.
FP-7-e.book 143 ページ ２００７年７月１２日 木曜日 午後３時４７分