Roland g-70 业主指南

r

G-70 Music Workstation

(8) To display the next 5 files, press the [˚] field in the 

lower right corner.
You can press this field as many times as necessary 
(or until it is no longer displayed). To return to a pre-
vious group of 5 files, press [ø].

(9) If you need to copy all files (on all available pages), 

press the [ALL¥FILES] field.

Note: If the memory card or floppy disk is not formatted, a 
message will be displayed that allows you to format it before 
the User Programs are copied.

(10) If you chose “EXT MEMORY” for “TO”, disable the 

card’s write protection (if available) and insert it 
into the PCMCIA slot. See the owner’s manual of 
the memory card for how to disable its write pro-
tection.
If you chose “FLOPPY DISK” for “TO”, disable its write 
protection (see p. 11) and insert it into the drive.

(11) Press the [EXECUTE] field.

You are asked whether it is OK to overwrite all files 
on the destination media (“TO”) that have the same 
file names as the files you are about to copy.

(12) Press the [YES] field if it is OK to overwrite files 

with the same names on the destination media. 
Press the [NO] field if files on the source (“FROM”) 
media that have the same name as existing files on 
the destination (“TO”) media should not be copied 
(only files with “original” names will be copied in that 
case).

The data are copied and a message confirms the end 
of the operation.

Note: Never remove the floppy disk or memory card while the 
operation is in progress. Wait for the confirmation to appear 
before returning to business as usual.

(13) Press the [EXIT] button to return to the main page.

Note: If the (remaining) storage capacity is smaller than the 
size of the files you wish to copy, the G-70 automatically stops 
the operation without displaying a message as soon as the 
media is full. Always check the contents of the destination 
media immediately after the copy operation to make sure that 
all required files have been copied.

It would be a good idea to also format floppy disks for-
matted for MS-DOS®, because that speeds up data 
access. Memory cards must always be formatted on 
the G-70: during formatting, the G-70 indeed also 
creates a number of folders where your various files will 
be stored.

(1) Defeat the disk’s or memory card’s write protection 

(if available):

(2) Insert the floppy disk into the drive or the memory 

card into the PCMCIA slot. 

(3) Press the [DISK&MEDIA] button.

(4) Press the [FORMAT] field.

(5) On the display page that appears now, press the 

[EXTERNAL¥MEMORY] or [FLOPPY¥DISK] field.
This obviously depends on whether you inserted a 
floppy disk or a memory card.

The display now responds with:

Floppy disk: Close the little “window” (page 11).

Memory card: See its owner’s manual (this depends on 

the kind of card you are using).