Roland JUNO-D 业主指南

Applying various effects to the sound

Quick Start

ASSIGNABLE

Specifies a function controlled by the D Beam controller.
Use VALUE [-]/[+] and select one of the following functions.

In Patch mode, the effect will apply to the patch. In Performance mode, the effect will
apply to the patch assigned to the current part. Use [DESTINATION TONE] to
specify the tone (p. 26).
“TxCC#” refers to the controller number of control change messages sent from the
MIDI OUT connector when the D Beam controller is operated. When set to
AFTERTOUCH, Channel Aftertouch messages are sent. Set to AFTERTOUCH
mainly when you want to control an external sound generator with Aftertouch
messages.
Receiving these control change messages from the MIDI IN connector produces the
same effect as moving the D Beam controller.

When set to MFX PARAMETER1 or MFX PARAMETER2, be sure to note the following.

• When the multi-effects Type is set to 01: STEREO EQ (p. 69) or 42: LOFI (p. 83),

Level is changed regardless of whether MFX PARAMETER1 or MFX
PARAMETER2 is selected.

• When the multi-effects Type is set to 23: 2V PCH SHIFT (p. 77), or 24: FB PCH

SHIFT (p. 78), the two parameters are changed simultaneously.

When making the LFO RATE, LFO DEPTH or LFO DELAY settings, the effect achieved
differs depending on whether [FILTER LFO] is on or off. When [FILTER LFO] is off, the LFO
alters the pitch (vibrato effect). When [FILTER LFO] is on, the LFO changes the Filter Cutoff
frequency (wah effect).

Value

Tx CC#

Function/Parameter Changed

MODULATION

CC01

Vibrato Effect

PORTA TIME

CC05

Portamento Time (p. 47)

VOLUME

CC07

Level