Roland JUNO-G 业主指南

 

This is a four-band stereo equalizer (low, mid x 2, high).

 

fig.MFX-01

 

This is a stereo spectrum. Spectrum is a type of filter which modifies 
the timbre by boosting or cutting the level at specific frequencies.

 

fig.MFX-02

 

This is an equalizer which cuts the volume greatly, allowing you to 
add a special effect to the sound by cutting the volume in varying 
ranges.

 

fig.MFX-03

 

Boosts the volume of the lower range, creating powerful lows.

 

fig.MFX-04

 

This is a filter with an extremely sharp slope. The cutoff frequency 
can be varied cyclically.

 

fig.MFX-05

 

Low Freq

200, 400 Hz

Frequency of the low range

Low Gain #

-15– +15 dB

Gain of the low range

Mid1 Freq

200–8000 Hz

Frequency of the middle 
range 1

Mid1 Gain

-15– +15 dB

Gain of the middle range 1

Mid1 Q

0.5, 1.0, 2.0, 4.0, 8.0

Width of the middle range 1

Set a higher value for Q to 
narrow the range to be af-
fected.

Mid2 Freq

200–8000 Hz

Frequency of the middle 
range 2

Mid2 Gain

-15– +15 dB

Gain of the middle range 2

Mid2 Q

0.5, 1.0, 2.0, 4.0, 8.0

Width of the middle range 2

Set a higher value for Q to 
narrow the range to be af-
fected.

High Freq

2000, 4000, 8000 Hz

Frequency of the high range

High Gain #

-15– +15 dB

Gain of the high range

Level #

0–127

Output Level

 

Band1 (250Hz)

-15– +15 dB

Gain of each frequency band

Band2 (500Hz)
Band3 (1000Hz)
Band4 (1250Hz)
Band5 (2000Hz)
Band6 (3150Hz)
Band7 (4000Hz)
Band8 (8000Hz)
Q

0.5, 1.0, 2.0, 4.0, 8.0

Simultaneously adjusts the 
width of the adjusted ranges for 
all the frequency bands.

Level #

0–127

Output Level

L in

R in

L out

R out

4-Band EQ

4-Band EQ

L in

R in

L out

R out

Spectrum

Spectrum

L in

R in

L out

R out

Isolator

Low Boost

Low Boost

Isolator

 

Boost/
Cut Low #

-60– +4 dB

These boost and cut each of the High, 
Middle, and Low frequency ranges.

At -60 dB, the sound becomes in-
audible. 0 dB is equivalent to the 
input level of the sound.

Boost/
Cut Mid #
Boost/
Cut High #
Anti Phase 
Low Sw

OFF, ON

Turns the Anti-Phase function on and 
off for the Low frequency ranges.

When turned on, the counter-
channel of stereo sound is inverted 
and added to the signal.

Anti Phase 
Low Level

0–127

Adjusts the level settings for the Low 
frequency ranges.

Adjusting this level for certain fre-
quencies allows you to lend em-
phasis to specific parts. (This is 
effective only for stereo source.)

Anti Phase 
Mid Sw

OFF, ON

Settings of the Anti-Phase function 
for the Middle frequency ranges

The parameters are the same as for 
the Low frequency ranges.

Anti Phase 
Mid Level

0–127

Low Boost Sw

OFF, ON

Turns Low Booster on/off.

This emphasizes the bottom to cre-
ate a heavy bass sound.

Low Boost 
Level

0–127

Increasing this value gives you a 
heavier low end.
* Depending on the Isolator and fil-

ter settings this effect may be hard 
to distinguish.

Level

0–127

Output Level

 

Boost 
Frequency #

50–125 Hz

Center frequency at which the lower 
range will be boosted

Boost Gain #

0– +12 dB

Amount by which the lower range 
will be boosted

Boost Width

WIDE, MID, 
NARROW

Width of the lower range that will be 
boosted

Low Gain

-15– +15 dB

Gain of the low frequency range

High Gain

-15– +15 dB

Gain of the high frequency range

Level

0–127

Output level

 

Filter Type

LPF, BPF, 
HPF, NOTCH

Filter type

Frequency range that will pass 
through each filter

 

: frequencies below the cutoff

 

 frequencies in the region of the 

cutoff

 

 frequencies above the cutoff

 

 frequencies other than the 

region of the cutoff

L in

R in

L out

R out

Low Boost

2-Band EQ

2-Band EQ

Low Boost

L in

R in

L out

R out

Super Filter

Super Filter

JUNO-G_e.book 132 ページ ２００６年７月３１日　月曜日　午後２時４９分