Roland JUNO-G 业主指南
173
About V-LINK
1.
Press [V-LINK] to access the V-LINK screen.
2.
Press [F6 (SETUP)].
The V-LINK SETUP screen appears.
fig.V-LINK-SETUP
3.
Use [
] [
] to move the cursor to the parameter you want to edit.
4.
Use the VALUE dial or [INC] [DEC] to set the value.
* :
On V-LINK compatible devices such as the Edirol DV-7PR/P-1, only Note Tx Channel A is used.
In motion dive .tokyo Performance Package, the Note Tx Channel corresponds as follows.
A: The MIDI channel that controls section A
B: The MIDI channel that controls section B
C: The MIDI channel that controls the MIDI note plug-in
5.
If you want to keep your settings, press [F6 (WRITE)].
6.
Press [F5 (EXIT)] or [EXIT] to return to the previous screen.
V-LINK Settings (V-LINK SETUP)
Parameter
Value
Explanation
Note Tx Channel A
1–16
Controls the V-LINK device. Specify the MIDI channel. (
*
)
Note Tx Channel B
Note Tx Channel C
D BEAM
Note Tx Channel C
D BEAM
Assigns a V-LINK function to the D Beam controller.
OFF
OFF
The operation selected by [D BEAM] will occur regardless of whether
V-LINK is on or off.
V-LINK is on or off.
ColorEQ Fore
CC1 (Modulation)
Used with motion dive .tokyo Performance Pack-
age
age
ColorEQ Back
CC71 (Resonance)
Scratch SW
CC3
Speed Knob
CC8 (Balance)
Total Fader
CC10 (Panpot)
Cross Fader
CC11 (Expression)
BPM Sync SW
CC64 (Hold)
Clip Loop SW
CC65 (Portamento)
Assign Knob
CC72 (Release)
Fade Time SW
CC73 (Attack)
Visual Knob
CC74 (Cutoff)
AB SW
CC81 (General-6)
Tap SW
CC83 (General-8)
Total Select
CC85
FX Select
CC86
Play Pos
CC91 (Reverb)
LoopStartPos
CC92 (Tremolo)
Loop End Pos
CC93 (Chorus)
LayerModeSel
CC94 (Celeste)
Dissolve Time
CC73 (Attack)
Used with the DV-7PR and similar devices.
Color Cb Ctrl
CC1 (Modulation)
Color Cr Ctrl
CC71 (Resonance)
Brightness Ctrl
CC74 (Cutoff)
VFX1 Ctrl
CC72 (Release)
VFX2 Ctrl
CC91 (Reverb)
VFX3 Ctrl
CC92 (Tremolo)
VFX4 Ctrl
CC93 (Chorus)
Fade Ctrl
CC10 (Panpot)
JUNO-G_e.book 173 ページ ２００６年７月３１日 月曜日 午後２時４９分