Roland juno-stage 用户指南
121
Chapter 9. Detailed Settings for a Rhythm Set
This shows the parameters of ZOOM EDIT, and additionally allows
you to edit in greater detail.
you to edit in greater detail.
1.
In Patch mode or Performance mode, select the patch that you
want to edit.
want to edit.
For details, refer to “Selecting Patches in Patch Mode” (p. 45) or
“Selecting a Patch for Each Part” (p. 50).
“Selecting a Patch for Each Part” (p. 50).
If you want to create a patch from scratch without using an
existing patch, execute the Initialize operation (p. 122).
existing patch, execute the Initialize operation (p. 122).
2.
Press [EDIT].
3.
Either press [3] or use the VALUE dial to select “RHYTHM EDIT,”
and then press [ENTER].
and then press [ENTER].
The ZOOM EDIT screen will appear.
4.
Press [7 (PRO EDIT)].
The PRO EDIT screen will appear.
5.
Press a key to select the rhythm tone (A0–C8) that you want to
edit.
edit.
6.
Use [3 (GRP
↑
)] [4 (GRP
↓
)] to switch between parameter groups.
Alternatively, you can switch between parameter groups by
pressing [2 (GRP LIST)] to access the Rhythm Pro Edit Menu
pressing [2 (GRP LIST)] to access the Rhythm Pro Edit Menu
window, then using the VALUE dial, [DEC] [INC], or [
] [
]
to select the parameter group, and pressing [ENTER].
7.
Use the cursor buttons to select a parameter.
fig.disp-rhyproedit.eps
8.
Press [TONE SWITCH/SELECT] so it’s lit, and use TONE SELECT [1]–
[4] to select the wave that you want to edit.
[4] to select the wave that you want to edit.
●
To edit the same parameter of multiple waves simultaneously
Simultaneously press TONE SELECT [1]–[4] for the waves that
you want to edit, so they’re lit in red.
you want to edit, so they’re lit in red.
●
To switch waves on/off
Press TONE SWITCH [1]–[4] to switch waves on/off.
You’ll be editing the waves for which a check mark (
You’ll be editing the waves for which a check mark (
✔
) is
shown for the tone numbers in the upper right of the screen.
9.
Use the VALUE dial or [DEC] [INC] to edit the value.
If you’ve selected more than one wave for editing, their values
will change while their relative differences are preserved.
will change while their relative differences are preserved.
10.
Repeat steps 5–9 to edit the parameters as desired.
11.
If you decide not to save the changes you made, press [EXIT] to
exit the PRO EDIT screen.
exit the PRO EDIT screen.
If you exit the PRO EDIT screen without saving, an “*” will be
displayed in the PATCH PLAY screen of Patch mode.
displayed in the PATCH PLAY screen of Patch mode.
If you turn off the power or select a different sound when the “*”
is displayed, the patch settings you edited will be lost.
is displayed, the patch settings you edited will be lost.
Viewing and Editing All Parameters
(PRO EDIT)
JUNO-STAGE_e.book 121 ページ ２００８年１０月１７日 金曜日 午後１２時２７分