Roland RD-700 业主指南

 

After pressing [MIDI TX], you can then set the following 
parameters affecting MIDI TX parts.

 

fig.LCD

 

Press [MIDI TX], getting the indicator to light.

The RD-700 is set to control the external MIDI devices.

 

Press CURSOR [

], [

], [

], or [

] to move the 

cursor to the parameter to be set.

You can get the cursor to move more rapidly by holding 
down the CURSOR button that points in the direction 
you want the cursor to move while you also press the 
CURSOR button that points in the opposite direction.

 

Press [INC/YES] or [DEC/NO] to set the value.

Press [INC/YES] and [DEC/NO] simultaneously to 
switch the Value to “--- (OFF).”

 

Sets the panning (localizes sound image) for each of the 
Tones.

The Volume setting is mainly used in the Split and Layer key 
modes to obtain the desired balance in volume between each 
part.

The Pan setting positions the sound image of each part when 
the output is in stereo. With an increase in the value for L, 
more of the sound will be heard as coming from the left side. 
Similarly, more of the sound will originate at the right if the 
value of R is increased. When set to 0, the sound is heard as 
coming from the center.

 

This sets the depth of the reverb and chorus effects.

 

Set the keyboard range in which each Part will sound.

This can be used to make notes in different areas of the 
keyboard play different Tones.

Specify the lower limit (LWR) and upper limit (UPR) of the 
key range being set.

 

This is effective only when [SPLIT] is on (p. 43) in the key 
range settings.

 

You cannot set the key range’s lower limit higher than the 
upper limit, nor can you set the upper limit below the lower 
limit.

 

You can use PART SWITCH for each individual part to select 
whether or not MIDI Note messages for that part are to be 

 

VOL (Volume)

CC07

0-127

PAN (Pan)

CC10 

L63–0–63R

 

REV (Reverb)

CC93

0–127

CHO (Chorus)

CC91

0–127

 

LWR (Lower)

A0–C8

UPR (Upper)

A0–C8

RD-700_e.book 63 ページ ２００４年４月２６日　月曜日　午前１１時５４分