Roland RD-700SX 业主指南

 

Up to two optional Wave Expansion Boards (SRX Series) can be installed in the RD-
700SX.

Wave Expansion Boards store Wave data, Patches, and Rhythm Sets, and by 
equipping the RD-700SX with these boards, you can greatly expand your sound 
palette.

For more information about the wave expansion board tones, refer to the patch list 
included with the wave expansion board. However, some of the tone names may be 
displayed differently on the RD-700SX. Check  36page as you refer to the tone names.

 

901

 

• To avoid the risk of damage to internal components that can be caused by static 

electricity, please carefully observe the following whenever you handle the board.

 

1

 

• Before you touch the board, always first grasp a metal object (such as a water 

pipe), so you are sure that any static electricity you might have been carrying 
has been discharged.

 

2

 

• When handling the board, grasp it only by its edges. Avoid touching any of the 

electronic components or connectors.

• Use a Philips screwdriver that is suitable for the size of the screw (a number 2 

screwdriver). If an unsuitable screwdriver is used, the head of the screw may be 
stripped.

• To remove a screw, rotate the screwdriver counter-

clockwise. To tighten a screw, rotate the screwdriver 
clockwise.

• Be careful that the screws you remove do not drop into 

the interior of the RD-700SX.

• Do not leave the rear panel cover removed. After installation of the Wave 

Expansion Boards is complete, be sure to replace the cover.

 

911

 

• Do not touch any of the printed circuit pathways or connection terminals.

 

912

 

• Never use excessive force when installing a circuit board. If it doesn’t fit properly 

on the first attempt, remove the board and try again.

 

913

 

• When circuit board installation is complete, double-check your work.

 

914

 

• Always turn the unit off and unplug the power cord before attempting installation 

of the circuit board.

 

915

 

• Install only the specified circuit board(s) (SRX Series). Remove only the specified 

screws.

• Be careful not to cut your hand on the edge of the installation bay.

Install the Wave Expansion Boards after removing the rear panel cover.

There are two slots (A and B) into which a board can be installed. Specify which slot’s 
board is to be used by pressing EXPANSION [A] or [B] on the front panel when 
using waves, tones, or Rhythm Sets from the wave expansion boards. 

tighten

loosen

RD-700SX_e.book 15 ページ ２００７年９月１２日　水曜日　午前１１時１０分