Roland RD-700SX 业主指南
26
Getting Ready
5
Press [ENTER].
A screen like the one shown below appears.
fig.00-15g
To cancel the Factory Reset, press [EXIT].
6
Press [ENTER].
The confirmation message appears.
fig.00-16g
To cancel the Factory Reset, press [EXIT].
7
Press [ENTER] once again to start the Factory Reset operation.
During the execution, “Executing... Don’t Power OFF” appears in the display.
After the Factory Reset operation is finished, the ONE TOUCH screen will appear.
8
Turn off the power to the RD-700SX, then turn it on again.
The characters in the display may be difficult to view immediately after turning on
the power or after extended use; this may also be because of where and how the
display is situated.
the power or after extended use; this may also be because of where and how the
display is situated.
In such instances, adjust the display contrast by turning the CONTRAST knob on the
front panel.
front panel.
fig.00-17p
Adjusting the Display Contrast (LCD Contrast)
You can also restore only part of the setting to their factory status. Refer to
“Restoring the settings to the factory condition (Factory Reset)”
“Restoring the settings to the factory condition (Factory Reset)”
RD-700SX_e.book 26 ページ ２００７年９月１２日 水曜日 午前１１時１０分