Roland RD-700SX 业主指南
70
Making Detailed Settings for Tones
These settings determine whether the pedals connected to each
PEDAL jack (DaMPER, FC1, FC2), the Modulation lever, the Bender,
and the Slides are used to control the Parts (ON), or not (OFF).
PEDAL jack (DaMPER, FC1, FC2), the Modulation lever, the Bender,
and the Slides are used to control the Parts (ON), or not (OFF).
You can make more detailed settings to the tones assigned to each of
the Internal parts.
the Internal parts.
In certain selected Tones, there may be parameters that cannot
be changed.
be changed.
1.
In the Tone screen, press [F1(Tone Info)].
The [F1] is lit, and the Tone Info screen appears.
fig.04-03g
2.
Press CURSOR [
]/[
] to switch screens, and
press CURSOR [
]/[
] to move the cursor to
the parameter to be set.
fig.04-04g
3.
Press [INC]/[DEC] to set the value.
4.
When you finish making settings, press [F1],
extinguishing its indicator.
extinguishing its indicator.
You are returned to the Tone screen.
The following parameters cannot be changed when the selected
tone is used as the Virtual Tonewheel tone.
tone is used as the Virtual Tonewheel tone.
• Mono/Poly
• Coarse Tune
• Fine Tune
• Portamento Switch
• Portamento Time
• Attack Time
• Release Time
• Cutoff
• Resonance
• Decay Time
Turning the Controllers in Each
Zone On and Off
Parameter
Description
Value
Dp
Damper pedal
ON, OFF
F1
Pedal connected to the FC1 jack
F2
Pedal connected to the FC2 jack
PB
Pitch Bender
Md
Modulation Lever
UP1
Control Slider (UP1)
UP2
Control Slider (UP2)
LW1
Control Slider (LW1)
LW2
Control Slider (LW2)
Making Tone Settings
(Tone Info)
How to Make Settings
RD-700SX_e.book 70 ページ 2007年9月12日 水曜日 午前11時10分