Roland PCR-1 业主指南
33
Getting Connected and Installing Drivers (Macintosh)
Mac OS 9 users
■
Installing the PCR-1 driver
Use either OMS or FreeMIDI as the MIDI driver.
The included
PCR-1 driver
is an add-on module for using the PCR-1 with OMS
or FreeMIDI.
* Either OMS or FreeMIDI must be installed in your Macintosh, as appropriate for the
sequencer software you are using.
Use the following procedure to install the PCR-1 driver.
1
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit this as well.
2
Prepare the CD-ROM.Insert the CD-ROM into the CD-ROM drive.
3
Double-click the
PCR-1 Driver-E Installer
icon (found in the
Driver E (Mac
OS 9)
folder of the CD-ROM) to start up the installer.
4
Verify the
Install Location
, and click
[Install]
.
fig.05-20
5
If a message like the following is
displayed, click
displayed, click
[Continue]
.
The other currently running
applications will exit, and
installation will continue.
applications will exit, and
installation will continue.
6
A dialog box will indicate
Installation was successful
.
Click
[Restart]
to restart your Macintosh.
OMS can be found in the
OMS 2.3.8 E
OMS 2.3.8 E
folder within
the OMS (Mac OS 9)
folder of the CD-ROM. If
you would like to know
more about OMS, refer to
OMS_2.3_Mac.pdf
folder of the CD-ROM. If
you would like to know
more about OMS, refer to
OMS_2.3_Mac.pdf
which
can be found in the same
folder.
folder.
If you install OMS or
FreeMIDI after installing
the PCR-1 driver, you
must install the PCR-1
driver once again.
FreeMIDI after installing
the PCR-1 driver, you
must install the PCR-1
driver once again.
If a PCR-1 is already connected to your Macintosh when you install the driver, a
message like the following will appear when the Macintosh is started up.
Perform the steps described below as appropriate for the message that is
displayed.
message like the following will appear when the Macintosh is started up.
Perform the steps described below as appropriate for the message that is
displayed.
If the screen indicates:
“Software needed for the USB device “PCR-1” is not available. Would you
like to look for the software on the Internet?”
“Software needed for the USB device “PCR-1” is not available. Would you
like to look for the software on the Internet?”
→ click [Cancel].
If the screen indicates:
“The software needed to use the USB device “PCR-1” cannot be found.
Please refer to the device documentation to install the necessary
software”.
“The software needed to use the USB device “PCR-1” cannot be found.
Please refer to the device documentation to install the necessary
software”.
→ click [OK].
Disconnect the PCR-1 from
the Macintosh before you
perform the installation.
the Macintosh before you
perform the installation.
The installation location
will be shown differently
depending on your
system. Make sure that
you have selected the
startup disk for the system
you are currently using.
will be shown differently
depending on your
system. Make sure that
you have selected the
startup disk for the system
you are currently using.
PCR-1_e.book 33 ページ ２００４年３月１６日 火曜日 午後２時５５分