Roland PCR-300 业主指南

 

You can set the controllers to the desired positions and then transmit their state as a 
“snapshot.”
The snapshot function will transmit the current values of the controllers [R1]–[R9], [S1]–
[S9], and [H1]–[H2] in a single operation.

 

This is a convenient way to send control data to your DAW software. You can 
use this to record initial values at the beginning of your song.

 

fig.H-SNAP.eps

 

Simultaneously press the [PRM MUTE] button 
and OCTAVE [-] button.
The [PRM MUTE] ([ENTER]) button will blink.

 

Press the [ENTER] button.
The [PRM MUTE] button will blink several times.

This completes transmission of the snapshot.

You can mute all controllers so that they will not transmit MIDI messages even if they 
are moved.

 

If a parameter value is distant from the current physical position of a controller, 
you can avoid an unwanted sudden jump in the value by using the [PRM MUTE] 
button to mute the controllers before moving the controller to a position that’s 
close to the current value.

 

fig.H-PRMMute.eps

 

Press the [PRM MUTE] button.
The [PRM MUTE] button will light, and the 
display will indicate “P ON.”

 

fig.D-PRMOn.eps

 

Operate the controllers.
At this time, MIDI messages will not be transmitted when you move 
the controllers.

 

fig.D-PRMOff.eps

 

Press the [PRM MUTE] button once again.
The [PRM MUTE] button will go out, and the display will indicate 
“POFF.”
Now, when you move the controllers, MIDI messages will once again be transmitted.

PCR-300_500_800_e.book 39 ページ ２００７年２月２８日　水曜日　午後７時１０分