Roland syb-5 业主指南

Changing the Battery

When the indicator goes dim or no longer
lights while an effect is on, it means that the
battery is nearly dead and must be replaced.
Replace the battery following the steps below.

* The use of an AC adaptor is recommended as the

unit’s power consumption is relatively high. Should
you prefer to use batteries, please use the alkaline type.

fig.12

1. Loosen the thumbscrew at the front of

the pedal, then lift the pedal upwards to
open the unit.

* The thumbscrew can be left in the pedal while

changing the battery.

2. Remove the old battery from the battery

housing, and remove the snap cord con-
nected to it.

3. Connect the snap cord to the new battery,

and place the battery inside the battery
housing.

* Be sure to carefully observe the battery’s polarity (+

versus –).

4. Slip the coil spring onto the spring base

on the back of the pedal, then close the
pedal.

* Carefully avoid getting the snap cord caught in the

pedal, coil spring and battery housing.

5. Finally, insert the thumbscrew into the

guide bush hole and fasten it securely.

Thumbscrew

Pedal

Spring Base

Coil Spring

Guide Bush
Hole

Battery Housing

Battery Snap
Cord

Battery
Snap

9V Battery