Roland PCR-30 业主指南
25
Español
Italiano
Français
Deutsch
English
Installing & Setting Up the
Driver (Macintosh)
Mac OS 9/8 users
■
Installing the driver
Use either OMS or FreeMIDI as the MIDI driver.
The included
PCR driver
is an add-on module for using the PCR-30/50/80
with OMS or FreeMIDI.
* Either
OMS
or
FreeMIDI
must be installed in your Macintosh, as appropriate
for the sequencer software you are using.
* Disconnect the PCR-30/50/80 from the Macintosh before you perform the installation.
Use the following procedure to install the PCR-30/50/80 driver.
1
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit this as well.
2
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive.
The installation procedure will differ depending on your system.
Please proceed to one of the following sections, depending on the system you use.
Please proceed to one of the following sections, depending on the system you use.
• Mac OS 9/8 users ................................................. (p. 25)
• Mac OS X users ..................................................... (p. 31)
• Mac OS X users ..................................................... (p. 31)
OMS
can be found in the
OMS 2.3.8 E
folder within
the
OMS
folder of the
CD-ROM. If you would
like to know more about
like to know more about
OMS
, refer to
OMS_2.0E_Mac.pdf
which can be found in
the same folder.
the same folder.
If a PCR-30/50/80 is already connected to your Macintosh when you install the driver, a message
like the following will appear when the Macintosh is started up. Perform the steps described below
as appropriate for the message that is displayed.
like the following will appear when the Macintosh is started up. Perform the steps described below
as appropriate for the message that is displayed.
If the screen indicates:
“Driver required for USB device ‘unknown device’ is not available. Search for driver
on the Internet?”
➔ click
[Cancel]
.
If the screen indicates:
“Software required for using device ‘unknown device’ cannot be found. Please refer
to the manual included with the device, and install the necessary software”.
➔ click
[OK]
.