Roland RD-700GX 用户指南

 

Connecting External MIDI Devices

 

Try Playing the RD-700GX from an external MIDI Device.

 

921

 

To prevent malfunction and/or damage to 
speakers or other devices, always turn down the 
volume, and turn off the power on all devices 
before making any connections.

 

fig.06-06e

After reading “Connecting the External Equipment 
to RD-700GX” (p. 23), connect an audio device/
system or headphones.

As described in “Turning On the Power” (p. 25), 
turn on the power of each device.

 

Set the RD-700GX’s receive channel to match the external 
MIDI device’s transmit channel.
For instructions on setting the RD-700GX’s Receive channel, 
refer to “Setting the Receive Channel (Receive Channel)” (p. 
127).
When both channels are matched, playing the external MIDI 
device produces sounds from the RD-700GX’s sound 
generator.

For instructions on how to set the transmit channel 
of the external MIDI device, refer to the owner’s 
manual for your external MIDI device.

Transmitting Bank Select (Controller Number 0, 32) and 
Program Change messages from the external MIDI device to 
the RD-700GX allows you to switch Setups and Tones.

The MIDI messages transmitted by the external MIDI device 
will be received by the RD-700GX to select Setups as shown in 
the following table.

When switching Setups, you must match the MIDI channel of 
the transmitting device with the RD-700GX’s Control channel 
(p. 110).
When switching the tones in each part, match the MIDI 
channel of the transmitting device with the RD-700GX’s 
Receive channel. However, when the Control channel and the 
Receive channel are both set to the same channel, the Control 
channel takes priority, and Setups are switched.

 

085

0

1–100

RD-700GX_e.book 140 ページ ２００８年２月１３日　水曜日　午後５時４９分