Roland RD-700GX 用户指南

 

Getting Ready

 

If you place the RD-700GX on a stand, you must use the KS-12 or KS-18Z (sold separately).

 

When placing the RD-700GX on the KS-12 or KS-18Z, place it in the position shown below.

Using the RD-700GX with any other stand may produce an unstable situation, possibly causing 
the instrument to fall or overturn, and resulting in injury or damage.

For details on how to assemble the stand, refer to the owner’s manual that accompanied the 
stand.

 

• Adjust the stand to a level no higher than the fourth level from the bottom.
• Adjust the width of the stand to the maximum width.

 

• Position the stand so that its arms extend toward the performer.
• Adjust the stand to the sixth level (842 mm) of the seven steps of width.

 

When placing the RD-700GX on the stand, be careful not to pinch your fingers between the 
instrument and the stand.

Place the RD-700GX 
so that its front edge 
is aligned with the tip 
of the stand’s arm.

Position the four rubber 
feet located on the 
bottom of the RD-700GX 
so that they are inside 
the arms of the stand.

Rubber Feet

Arm

Position the four rubber 
feet located on the bottom 
of the RD-700GX so that 
they go into the holes in 
the arms of the stand.

Rubber Feet
Arm
Hole

842 mm

Performer

RD-700GX_e.book 21 ページ ２００８年２月１３日　水曜日　午後５時４９分