Roland RD-300SX 业主指南
13
Getting Ready
941
Once the connections have been completed, turn on power to your various devices
in the order specified. By turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
in the order specified. By turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
1
Before you switch on the power, turn the volume down all the way using the
VOLUME slider.
Also completely turn down the volume of any connected audio device and other
equipment.
equipment.
fig.00c-05
2
Press the [POWER] switch on the back of the unit.
The power will turn on, and “Pno” appears in the display.
fig.00c-06
3
Turn on the power to connected external devices.
4
Adjust the volume of the connected external device.
5
Adjust the RD-300SX’s volume to obtain the proper volume level.
Turning the Power On and Off
Turning On the Power
To prevent incorrect
functioning of the Pitch Bend
Lever (p. 30), refrain from
touching the lever when you
turn on the power.
functioning of the Pitch Bend
Lever (p. 30), refrain from
touching the lever when you
turn on the power.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
942
Rear Panel
Lower Position
ON
RD-300SX_e.book 13 ページ 2005年12月26日 月曜日 午後8時37分