Roland RS-70 业主指南

 

The checksum of a received System Exclusive mes-
sage was incorrect.

Set the correct checksum value.

 

Due to an inordinate volume of MIDI messages re-
ceived, the RS-70 has failed to process them properly.

Reduce the amount of MIDI messages to be transmit-
ted.

 

A problem has occurred with the MIDI cable connec-
tions.

Check that MIDI cables are not broken or pulled out.

 

A MIDI message was received incorrectly.

If the same error message is displayed repeatedly, the 
problem lies with the MIDI messages that are being 
transmitted to the RS-70.

 

The data in user memory has been lost.

Use the Factory Reset function to initialize the mem-
ory to the factory settings.

 

It is possible that the power has been turned off for the 
computer connected to the RS-70’s USB connector.

Check the power of the connected computer.

It is possible that a USB cable has been pulled out or 
has a short.

Check that USB cable is not broken or pulled out.

 

There is no file that the RS-70 can use. (Note: This will 
be displayed if there is no file with an extension of 
RSU or MID.)

—

 

A disk is not inserted in the disk drive.

Insert a disk.

 

This disk cannot be used by the RS-70.

Format the disk on the RS-70.

 

Since the write protect tab of the disk is in the Protect 
position, data cannot be written to the disk.

Set the write protect tab to the Write position, and re-
try the operation.

 

This disk is a master disk. Master disks cannot be 
used to save data or be formatted.

—

 

A file is corrupted, the disk is scratched or damaged, 
or the disk drive is malfunctioning.

Insert another disk formatted on the RS-70 (not con-
taining important data). If this solves the problem, 
the problem is probably a scratched or damaged disk, 
or a corrupted file. Do not use the disk. If the same er-
ror message appears repeatedly, a malfunctioning 
disk drive is suspected.
If the disk drive is malfunctioning, it could damage 
the disk. Consult your dealer or closest Roland ser-
vice station.

 

The maximum number of files that can be created has 
been exceeded.

Delete unneeded files.

 

The RS-70 cannot handle this file.

—

 

The operation you attempted to execute is not appro-
priate for this disk. (Note: This will be displayed if 
you insert a different disk during disk backup.)

Do not select this disk as the object of the operation.

 

Internal memory is full, preventing processing of the 
data.

Delete unneeded data, reducing the amount of data 
in the pattern.

 

A file with the same name already exists on the disk.

Use a different file name.

 

Insufficient free space available on the disk to save 
the data.

Either insert a different disk (formatted on the RS-70) 
or delete unnecessary data and retry the operation.

 

There is a space within the file name.

Change the file name.

 

Since data was not found at the specified location, the 
operation could not be executed. (This will be dis-
played if there is no applicable data for the Micro-
scope.)

Specify the correct location.

 

Processing is canceled. (This is not an error message.)

—

RS-70_e4.book 164 ページ ２００３年８月１８日　月曜日　午前９時４７分