Roland PCR-300 业主指南

 

Here’s how to assign an aftertouch message to a controller.

 

fig.H-Edit.eps

 

Press the [EDIT] button so it’s lit.

 

fig.D-Edit.eps

 

The display will indicate “EDIT.”

 

fig.D-r1.eps

 

Slightly move the controller to which you want to assign aftertouch.
If the controller is a button, press it.
The display will indicate the controller number you selected.

 

Check the indication in the display, then press the [ENTER] button.

 

fig.D-AfterEdit.eps

 

Turn the VALUE knob to make the display indicate “AT.”

 

Press the [ENTER] button.

 

fig.D-AfterEdit0.eps

 

Turn the VALUE knob or press controller [A1 (0)] to get the “AT0” 
indication (basic editing).

 

fig.D-ChannelSelect.eps

 

Press the [ENTER] button.
The display will indicate “CH- -.”

 

Enter the channel.
Use the VALUE knob or controllers [A1 (0)]–[B2 (9)] to specify the desired channel.

 

Press the [ENTER] button.

 

 

Basic editing

[A1 (0)]

Channel Pressure

1–16

0–127 (00–7FH)

PORT1

(fixed)

Unlatch, Latch, 

Increase

Advanced editing 1

[A2 (1)]

Channel Pressure

1–16

You can specify an 

upper and lower limit

PORT1, 
PORT2, 

PORT1+2

Unlatch, Latch, 

Increase

Advanced editing 2

[A3 (2)]

Polyphonic Key Pressure

1–16

0–127 (00–7FH)

PORT1

(fixed)

Unlatch, Latch, 

Increase

Advanced editing 3

[A4 (3)]

Polyphonic Key Pressure

1–16

You can specify an 

upper and lower limit

PORT1, 
PORT2, 

PORT1+2

Unlatch, Latch, 

Increase

PCR-300_500_800_e.book 44 ページ ２００７年２月２８日　水曜日　午後７時１０分