Roland PCR-300 业主指南

下载
页码 100
 
88
 
Two MIDI ports
 
If the PCR is connected to your computer via USB, the PCR will be able to use two MIDI output ports (PORT 1 and PORT 2). Each controller of the PCR can be assigned to send its MIDI 
messages to either port.
For details on how to make this assignment, refer to 
 
 
 
 
 
fig.MIDI-port1-e.eps_55
 
If you’re using DAW software, and you’re simply controlling the sound module for the part 
that’s producing the sound, the PCR’s controllers can use the same MIDI output port as the 
keyboard. When the PCR is in the default state, the PCR’s keyboard performance data will 
also be sent from PORT 1, so you can assign the controllers to PORT 1 as well.
 
fig.MIDI-port2-e.eps_55
 
Some DAW software has an input port used to control the mixer section of the DAW 
software. Since the PCR has two MIDI output ports, you can use one port to play sounds and 
control the sound module, while using the other port to control your DAW software.
 
fig.MIDI-port3-e.eps_55
 
For example, if you want to use the PCR’s [A1]–[A9] and [B1]–[B9] buttons to switch sounds 
on your sound module, and use the [S1]–[S9] sliders to control the volume faders of your 
DAW software’s mixer, you could assign the controllers to MIDI output ports as follows.
   [A1]–[A9] and [B1]–[B9] buttons: PORT 1
   [S1]–[S9] sliders: PORT 2
 
* For details on how to control your DAW software, refer to the owner’s manual for the DAW software 
you’re using.
Track
:
PCR 1
DAW software
MIDI sound module
MIDI OUT
PCR 2
Software 
synthesizer
THRU
Recorded 
on a track
PCR
PORT1
PORT2
DAW software
Software 
synthesizer
Recorded 
on a track
Track
:
PCR 1
MIDI OUT
PCR 2
PCR
PORT1
PORT2
DAW software
MIDI sound module
Software 
synthesizer
Recorded 
on a track
Track
:
PCR 1
PCR
PORT1
PORT2
MIDI OUT
PCR 2
THRU
PCR-300_500_800_e.book 88 ページ 2007年2月28日 水曜日 午後7時10分