Roland rd-170 业主指南

RD-170 Edit parameters and Setup memories

r

(2) Press the [UPPER] (red) or [LOWER] (green) 

button to select the part whose setting you 
want to change.

(3) Use [DEC÷NO]/[INC÷YES] to set the send level 

value (0~127). Simultaneously press [DEC÷NO] 
and [INC÷YES] to select off if the selected 
part should not transmit any CC93 value 
when you select the Setup memory in ques-
tion (this is the default setting).

(4) Press [EXIT] (or [EDIT]) to leave the Edit mode 

or select the other part and change its setting 
too.

Note: This setting can be saved (see p. 28).
Note: If there is no audible change, you may have to 
check the Chorus effect settings on the receiving MIDI 
instrument.
Note: Not all MIDI instruments have a Chorus effect 
and even if they do, they may not support this control 
change number (this is especially true of older instru-
ments).

→[MIDI]

Here are three parameters that allow you to specify 
whether (on) or not (off) the damper pedal, foot-
switch (or expression pedal) and/or PART LEVEL slid-
ers should transmit (TX) the corresponding MIDI 
messages:

(1) Press [EDIT] (lights), followed by [10], [11] or 

[12].

Press and hold the numeric button in question 
to display the abbreviated function name.

(2) Press the [UPPER] (red) or [LOWER] (green) 

button to select the part whose setting you 
want to change.

(3) Use [DEC÷NO]/[INC÷YES] to select on (transmit) 

or off (do not transmit).

(4) Press [EXIT] (or [EDIT]) to leave the Edit mode 

or select the other part and change its setting 
too.

Note: This setting can be saved (see p. 28).

[10] CC64

Footswitch connected to the PEDAL 
DAMPER socket.

[11] CC66

CC67
CC11

Sostenuto
Soft
Expression
Footswitch or pedal connected to the 
SOFT/EXPR. socket. Its function depends 
on the setting selected for “Second 
pedal” (p. 22) and “Pedal detection” 
(p. 30).

[12] CC07

PART LEVEL sliders

off

Sustain tr

2nd pedal tr

Slider tr

RD-170 OM_GB  Page 26  Monday, March 17, 2003  10:23 AM