Brady BP-IP300 用户指南
Installation
7
3. Connect the printer to the computer using the supplied USB cable, an
RS-232 cable or an Ethernet cable (refer to Interface Connections on
page 7).
page 7).
4. If you do not have BradySoft, LabelMark or IdentiLab software installed
on your computer, refer to Software Installation on page 13.
5. Turn on the power switch on the back of the printer (Figure 2, 5). The
printer will perform a self test and then go into Ready mode.
NOTE: If a fault occurs during the system test, the symbol
and the
type of fault are displayed on the LCD display. Refer to
Troubleshooting Chart on page 62 for additional information.
Troubleshooting Chart on page 62 for additional information.
Interface Connections
The printer has an RS-232 port (Figure 2, 1), a USB port (Figure 2, 2) and an
Ethernet port (Figure 2, 3).
Ethernet port (Figure 2, 3).
Figure 2, Interfaces and Connectors
1. RS-232 port
4. Power connection socket
2. USB port
5. Power switch
3. Ethernet port
1
2
2
3
4
5
5